Zavig B8210 Manual de usuario Pagina 2

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 142
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 1
Copyright © 2014 NUUO Inc. All rights reserved.
www.nuuo.com
2
NVR Device Pack Release Note
NUUO version 3.7.0
2 / 142
Zavio
B8210( FW: M201.0_M2.8.8)
Multiple Stream Setting Supported:
SNC-ER580, SNC-CH160, SNC-DH110, SNC-DH220
Notice:
1. ACTi
a. E97
i. The actual framerate may not reach the setting value under high resolution and
quality configuration. (Camera performance limitation)
ii. The 2
nd
streams actual bitrate is higher than settings.(Camera firmware issue)
iii. The function send mail by event might fail to attach snapshot under high resolution
(NUUO server limitation)
iv. The motion signal would not stop when disabling motion event if the motion has been
triggered. (NUUO server limitation)
2. Bosch (Mainconsole IP+)
a. VIP X16 XF E
i. Only support G.711 audio codec. (Camera performance limitation)
ii. Snapshot resolution is not correspond to existing profile. (Camera firmware issue)
iii. Multi stream setting might fail due to the limitation of inter-streaming dependency.
(NUUO Server limitation)
3. BrainChild
a. CAM-335E
i. Camera is unable to achieve maximum FPS under main or 2
nd
stream with high bitrate.
(Camera performance limitation)
ii. High resolution and bitrate would cause stream latency. (Camera performance
limitation)
iii. After setting camera parameters , NUUO server cannot get video parameters and
connect camera immediately (Camera performance limitation)
iv. If setting video and audio at the same time, the changed configuration wouldnt apply
to stream (Camera firmware issue)
v. MJPEG quality value on camera web is different from the value NUUO server display
(Camera firmware issue)
vi. Motion detection does not work when main streams format is MJPEG (Camera Issue)
Vista de pagina 1
1 2 3 4 5 6 7 ... 141 142

Comentarios a estos manuales

Sin comentarios